Delphi SA10116-11B1 manual Setting Up the Home Antenna

s e c t i o n t w o 2

Section 2: Setting Up the Delphi XM Satellite Radio Signal Repeater

To quickly begin using your Signal Repeater, follow the steps in this section. You may also have to refer to your satellite radio receiver user guide, available at www.shopdelphi.com.

Setting Up the Home Antenna

Before setting up your Signal Repeater, set up your XM home antenna by following the instructions that came with your Delphi XM receiver home kit or audio system. Check to make sure you are receiving a signal with no error messages on the display. If you do not receive a signal or your satel- lite radio receiver’s display reads “NO SIGNAL,” try moving the satellite radio antenna to a new location. (A south-facing window is ideal.) If you are receiving an “ANTENNA” error message, do the following:

1.Turn your satellite radio receiver off, wait 10 seconds, then turn it back on.

2.Recheck the antenna connection.

3.Inspect the antenna cable to ensure it is not crimped, cut, or damaged.

4.If these actions do not have any effect, contact your retailer.

Caution: When testing the equipment, keep the transmitter and repeater antenna at least 3 feet apart. Placing them too close to each other could result in no operation due to an overly powerful signal.