Getting Started
Using Roady® XT with Delphi Premium Sound System
1.Install the Roady XT cradle onto the Delphi Premium Sound System. Insert the Roady XT Receiver (sold separately) into the adaptor included with the Delphi Premium Sound System until snug.
Caution: Do not use excessive force when inserting the receiver into the cradle. Doing so could cause damage to the unit.
2.Insert the adaptor containing the Roady XT into the cradle by pressing in on the back of the black inset cradle in the Delphi Premium Sound System. Then let the cradle tilt forward and carefully slide the adaptor down into the tray so that the alignment tabs on the sides of the tray line up with the slots on the adaptor and the connector is completely seated.
Push on the top center above the display of the adaptor so that it tilts back into the Delphi Premium Sound System until a click is heard. The Roady XT receiver adaptor can be removed by reversing this process.
3.Power up the system by using the power button on the receiver or on the remote control. If the display reads “ANTENNA” after powering up, check that the antenna connection is secure and completely pushed in. Next, change channels (from 0 to 1 or from 1 to 0 if the receiver is not activated yet). If the “ANTENNA” message remains, power down the radio, unplug the antenna and look for any obvious damage in the connector, jack or antenna cable. If no damage is detected, reconnect the antenna, turn the unit back on and change channels again. If the message still appears, contact your retailer.
12
