Custom Fit Connections - Plastic Sleeve Installation Instructions

Correct method

1.Identify desired length of tube (1). Leave 1" - 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free.

2.Slide nut (2) and plastic sleeve (3) onto cut tube. Ensure sleeve is oriented as shown.

3.Insert tube into outlet fitting (4). Tube should touch bottom of hole inside fitting.

4.Slide plastic sleeve down tube until it engages

top of fitting. WARNING: Failure to use plastic

 

 

2

 

 

sleeve in the correct orientation will result in disconnection and possible water damage.

5.Slide nut over plastic sleeve. With wrench,

tighten nut 2 turns past finger tight.

3

 

 

1

 

4

Incorrect Installation

1

2

Do not install sleeve

Do not use RP51243 Ensure cut is straight.

Ensure tube is fully

upside down.

gasket (1) supplied

inserted into stop

 

with PEX tubing or

before sliding sleeve

 

brass ferrule (2)

down to engage top

 

supplied with

of fitting.

 

valve stops.

 

9

Page 9
Image 9
Delta 16968-DST Series manual Incorrect Installation