ASSEMBLY
1.Assemble column (A) Fig. 4, to base (B) using four 1- 3/4" long screws (C), three of which are shown. Loosely thread locking lever (D) into table mounting bracket (E), as shown. Loosely thread remaining locking lever (F) Fig. 5, into split of table mounting bracket (E).
2.Insert table (G) Fig. 5, into table mounting bracket
(E) and tighten lever (D) to lock table in position. Tighten locking lever (F) Fig. 5, to lock table raising mechanism on the column.
3.Assemble table raising and lowering handle (H) Fig. 5, to table mounting bracket (E). Align the set screw on handle (H) with the flat on the shaft extending from the mounting bracket and tighten securely with the 3mm hex wrench supplied with the tool.
4.Carefully position drill press head (J) Fig. 6, onto column (A) as far as it will go. Align drill press head (J) Fig. 6, and table (G) Fig. 5, with the base of the drill press, which was assembled in STEP 1, and tighten locking lever (K) and set screws (L) with the 5mm hex wrench (M) supplied.
E
D
A
B
C
Fig. 4
G
E
D
E
H
F
Fig. 5
K
L M
J
A
Fig. 6
5
