ADDITIONAL SPECIFIC SAFETY RULES
12.Never reach into the cutterhead area while the machine is running. Your hands can be drawn into the knives.
13.Do not stand in line of the workpiece. Kickback can cause injury.
14.Allow the cutterhead to reach full speed before feeding a workpiece.
15.When planing bowed stock, place the concave (cup down) side of the stock on the table and cut with the grain to prevent kickback.
16.Do not feed a workpiece that is warped, contains knots, or is embedded with foreign objects (nails, staples, etc.). Kickback can occur.
17.Do not feed a short, thin, or narrow workpiece into the machine. Your hands can be drawn into the knives and/or the workpiece can be thrown at high speeds. See the “operation” section of this instruction manual for details.
18.Do not feed a workpiece into the outfeed end of the machine. The workpiece will be thrown out of the opposite side at high speeds.
19.Remove shavings only with the power “off” to prevent serious injury.
20.Properly support long or wide workpieces. Loss of control of the workpiece can cause serious injury.
21.Never perform layout, assembly or
22.Turn the machine “off”, disconnect it from the power source, and clean the table/work area before leaving the machine. Lock the switch in the “off” position to prevent unauthorized use. Someone else might accidentally start the machine and cause injury to themselves or others..
23.Additional information regarding the safe and proper operation of power tools (i.E. A safety video) is available from the power tool institute, 1300 sumner avenue, cleveland, oh
SAVE THESE INSTRUCTIONS.
Refer to them often and use them to instruct others.
5
