CHECKING AND ADJUSTING BED ROLL HEIGHT
The height of the bed rolls (A) and (E) Fig. 23A, should be set between .002" and .004" above the table surface, with the bed rolls at their lowest position. To check the infeed bed roller height setting, proceed as follows:
1.
DISCONNECT MACHINE FROM POWER SOURCE
2.Turn height adjustment knob (B), counterclockwise as far as it will go.
3.Place a straight edge (C), across the infeed and out- feed rollers on the left side of the table as shown.
4.With a feeler guage (D), measure the gap between the table surface and the straight edge (C) near the infeed roll (E).
5.If an adjustment to the infeed roller (E), is necessary, loosen set screw (F) Fig. 23B, located underneath the left front end of the table.
6.Turn adjustment collar (G) Fig. 23B left or right as needed to attain proper height adjustment.
7.Tighten set screw (F) Fig. 23B after adjustment is made.
To check the outfeed roller height setting, proceed as follows:
1.With a feeler guage (H) Fig. 23C, measure the gap between the table surface and the straight edge (C) near the outfeed roller (E).
2.If an adjustment to the outfeed roller is necessary, loosen jam nut (K) Fig. 230, located on the left side of machine under the table, and turn collar (L) right or left as needed until the outfeed roller is adjusted properly.
3.Tighten jam nut (K) Fig. 23D.
A
C
D
E
B
Fig. 23A
G
F
Fig. 23B
C
H
E
Fig. 23C
K
L
Fig. 23D
15
