ASSEMBLY
TOOL RESTS
1. Assemble left tool rest (A) Fig. 3, to left tool rest arm |
(B), as shown, and fasten with one |
head screw (C) and 5/16" flat washer (D). Assemble the |
remaining tool rest in the same manner. Do not |
completely tighten hardware at this time. |
A
C
2. Assemble left tool rest assembly (D) Fig. 4, to the |
inside of left wheel guard (E), and fasten with two 5/16- |
18x5/8" screws (F) and 5/16" flat washers (G) as shown. |
3. Assemble right tool rest assembly to the inside of |
right wheel guard and fasten with two |
head screws and 5/16" flat washers in the same manner. |
4. Each tool rest assembly (D) Fig. 4, is adjustable so it |
can be positioned slightly below the centerline of the |
wheel and as close to the grinding wheel as possible, |
giving maximum support to the piece that is being |
ground. Always maintain a distance of 1/8" or less |
between the grinding wheel and the inside edge of the |
tool rest. As the wheels wear down, the tool rest should |
be adjusted accordingly. When the tool rest is positioned |
correctly, tighten hardware (C) and (F). Freehand |
grinding without the use of a tool rest should always be |
done on the lower quarter of the wheel. |
D
B
Fig. 3
G
D
CF E
Fig. 4
SPARK GUARDS
The spark guard (A) Fig. 5, is mounted to the side of each wheel guard, using the
Fig. 5, on the side of the spark guard (A), must be placed in slot (E), before attaching the spark guard
C
A 
B
D
(A)to the grinder. The spark guard (A) should be adjusted as close as possible to the grinding wheel so that sparks never strike the operator’s hand. As the wheels wear down, the spark guard (A) should be adjusted accordingly.
EYE SHIELDS
Your grinder is supplied with two eye shields for operator protection. 
WARNING: ALWAYS WEAR EYE PRO- TECTION. To assemble the eye shields, proceed as follows:
1.Place the eye shield on the spark guard as shown in Fig. 6.
E
Fig. 5
Fig. 6
5
