Chapter 6 | Replacing Parts |
Replacing the PCI Hot-Swap Assembly
The Olx board is mounted within the slot cover on the rear of the HP NetServer. To access the Olx board it is necessary to remove the slot cover from the rear panel.
1.Remove the two screws mounting the cover to the rear panel.
2.Access the interior and disconnect the Olx cable from the I/O board.
3.Remove the Olx circuit board from the housing by moving the two tabs that fit over the board and hold it to the housing.
Install the replacement board by aligning it component side toward the housing and aligning the mounting hole on the board to the post on the housing. The board will then snap into place.
103
