Chapter 5 | Troubleshooting |
2.Power down the HP NetServer.
3.Disconnect the power cords and cables and, if necessary, label each one to support re- assembly.
CAUTION The power supplies will continue to provide standby current to the NetServer until the power is disconnected.
4.For both
NOTE | In the LH 6000r, this assembly is under the right cover; in the LH 6000, it is under |
| the top cover. |
While you can clear the system configuration in the rack or in the pedestal, it is recommended that you remove the system board assembly to perform configuration changes
1O CPU Speed
2 N CPU Speed
3CPU Speed
4
5Clear Config
6Clear Password
7
8Not Used
System Board Assembly and Configuration Switch
5.Move the configuration switch, switch 5 on the system board, to the "ON = CLEAR CONFIG" position.
58