Chapter 4

Diagnostics

3.If the cable is damaged, connect the hard disk drive to another IDE cable, if available.

4.If the problem persists, your hard disk drive may need to be replaced. Contact your service representative.

Error codes #0520, #0521, #0522, #0523 respectively apply to HDD0, HDD1, HDD2, and HDD3 as described in the Setup utility.

053X A hard disk drive has been found on the second (slave) position on the IDE cable, but no hard disk has been found on the first (master) position.

This message applies to the primary channel cable marked IDE1 (#0530) or to the secondary channel cable marked IDE2 (#0531).

1.If only one hard disk is connected on the cable, use the other connector to connect the hard disk in the first (master) position.

2.If two disks are connected on the cable, check that all cables and power cords are firmly connected for both hard disk drives.

3.If the error message appears just after a hard disk drive installation, check the hard disk drive installation manual for master/slave specific jumper configuration.

0600 The video memory size detected during the power-on self-test is smaller than previously detected. The video memory module is either disconnected, defective or has been replaced by a smaller one.

1.If the video memory module has just been removed or replaced by a smaller one, press [F4] to automatically validate the change.

2.If the video memory modules have not been removed or changed, ensure they are properly inserted in their sockets.

3.If the problem persists, your video memory module may need to be replaced. Contact your service representative.

0700 The system memory size detected during the power-on self-test is smaller than previously detected. One or several main memory modules are either disconnected, or have been replaced by smaller ones.

1.If some main memory modules have just been removed or replaced by smaller ones, press [F4] to automatically validate the change.

2.If no main memory module has been removed or changed, ensure all modules are properly inserted in their sockets.

3.If the problem persists, one of your main memory modules may need to be replaced. Contact your service representative.

07XX One main memory module has reported an error during its self-test.

(This error may cause serious problems to the HP NetServer operation.)

1.Isolate the defective memory module using the error code 07xy with x = bank number, y = module number. The memory module sockets are put in the following order: 071X=A, 072X=B, and 073X=C.

2.Remove the memory module from its socket and clean the edge connector. Refer to your HP NetServer LH 6000/LH 6000r Installation Guide for handling precautions.

3.Re-install the memory module.

52