HP LH 6000 manual Switch Settings, Power Requirements

Chapter 2System Information

Depth	724.2 mm (28.5 in)
Weight	72.6 – 78.5 kg (160 - 173 lb.)
HP NetServer LH 6000r
Height	354.7 mm (14 in)
Width	482.6 mm (19 in)
Depth	749.2 mm (29.5 in)
Weight	72.6 – 78.5 kg (160 - 173 lb.)

Power Requirements

Power Supply Specifications: Three power supplies, plus one for redundancy

Power supply type		Wide range, PFC
Input voltages:
Nominal:		100 to 240 VAC, 11.7A/5.6 A at 50/60 Hz
Range:		90 to 264 VAC at 47 - 63 Hz
Power availability:		780 W continuous
Minimum System Requirements
Voltage	Volt/Amps	Amps	Watts
100	1177	11.7	1166
120	1153	9.6	1141
200	1120	5.6	1099
230	1117	4.9	1095

Switch Settings

The configuration switch, S1, is located on the lower left of the system board of the system board assembly. To change the switch settings, it is recommended that the system board assembly be removed from the chassis.

NOTE	Only the first four switches set the processor speed. Do not change the processor
	speed switch settings.

28