HP LH 6000 manual Boot Priority, IRQ Settings, Video Connector Pinouts

2 System Information

Boot Priority

Some boards have preferred slot locations. Consider the boot order when choosing the accessory board slot in which to install the accessory board.

This is the default boot priority for the LH 6000/6000r:

1.IDE CD-ROM drive with a bootable CD-ROM

2.Flexible disk drive with a bootable flexible disk

3.HP NetRAID controller or integrated Embedded SCSI controller

4.PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, and 1 Change this boot order using the Setup utility.

IRQ Settings

The BIOS automatically assigns the IRQs (hardware interrupts) for each PCI slot and embedded device in the HP NetServer during boot. These assignments trigger the NOS to enable the APIC (Advanced Programmable Interrupt Controller). APIC takes advantage of the expanded set of non-conflicting IRQs for those accessory boards requiring more than one IRQ per slot. APIC provides up to four dedicated interrupts for each PCI slot.

These automatic IRQ assignments can be changed in the setup screen (F2).

Connector Pinouts

Unless otherwise noted, the following features apply to all models. Some features are factory installed; others are optional.

Video Connector Pinouts

The built-in video uses the standard 15-pin analog display pinout configuration. The pinouts for your monitor may vary. For the pinouts for your monitor, refer to the manual that came with your monitor.

6
	1	11
7
	2	12
8
	3	13
9
	4	14
10
		15
	5

Video Connector Pinouts

17