Delta 28-241, 28-299A instruction manual Attaching the Switch, Attaching Band SAW To the Stand

ATTACHING BAND SAW

TO THE STAND

CAUTION: The band saw is very heavy. Use a helper when attaching the saw to the stand.

Attach the band saw to the stand by using the four holes provided (two of which are shown at (A) Fig. 8). Place one 5/16-18 x 1-3/4" hex head screw with a 5/16" flat washer through each hole in the bottom of the band saw and the top of the stand. Thread a 5/16" flange nut on screw and tighten securely.

ATTACHING AND ALIGNING V-BELT, ADJUSTING BELT TENSION

1.Attach the V-belt (E) Fig. 9 on the two pulleys (A and B), and adjust the belt tension by raising or lowering the motor

(C) on the motor mounting bars (D). (If necessary, the motor mounting bars (D) can be repositioned on the two posts (F) Fig. 9. Tension is correct when the belt is deflected approxi- mately 1" in the center.

2.Place a straight edge against the belt along the V-groove of both pulleys. Visually check to see that both pulleys are in line. Either pulley can be moved in or out by loosening the set screw (the lower pulley set screw is shown at (B) Fig. 7). After aligning, tighten the set screw. The motor can also be moved on the mounting bars.

A

A B

Fig. 8

A

D

E

F

F

C

B

Fig. 9

ATTACHING THE SWITCH

A push-button switch (mounted in a switch box), and a cord set are supplied with the unit. To attach the switch to the band saw arm, do the following:

1.DISCONNECT TOOL FROM POWER SOURCE.

2.CAUTION: The switch-to-motor cord (F) Fig. 11 must be tied to the horizontal motor support bar (G). This cable tie (H) prevents the switch-to-motor cord (F) from contacting the belt or motor pulley during operation of the unit.

IMPORTANT: Leave this cable tie in place. Remove it ONLY when using the Accessory Height Attachment with the machine.

B

A

H

G

F

Fig. 11

D

C

Fig. 12 Fig. 13

3.Remove the two outer hex nuts and lock washers (A) Fig. 12 from the two screws extending out from the back of the switch box (B).

4.Insert two screws (C) Figs. 13, located on back of switch box, into two holes (D) located in the band saw arm.

7