E
Fig. 14
F
E
Fig. 15
5.Use the two nuts and lockwashers (E) Fig. 14, removed in STEP 3, to fasten the switch box to the bandsaw arm (Fig. 14).
6.Remove the screw (F) and cable clamp (E) Fig. 15 from the lower arm of the band saw.
7.Insert the switch cord and power cord (F) Fig. 16 into the clamp (E) (removed in STEP 6), and fasten to the bandsaw.
8.Push connector end of switch cord through the plastic bushing (G) Fig 16A. and plug it into the motor cord.
IMPORTANT: Be certain to prevent contact between the
9. Attach the two side panels removed earlier.
F
E
Fig. 16
M
G
K
L
Fig. 16A | Fig. 17 | Fig. 18 |
STARTING AND STOPPING SAW
To start the tool, press the “START” button (K) Fig. 17. To stop the tool, press the “STOP” button (L) Fig. 17.
LOCKING SWITCH IN THE OFF POSITION
IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unau- thorized use, using a padlock (M) Fig. 18 with a 3/16" diameter shackle.
TABLE INSERT
Place the table insert (A) Fig. 19 in the hole provided in the table. Engage the protrusion on the insert in the indent (B) in the table.
B
A
Fig. 19
8
