ASSEMBLY

ON-BOARD STORAGE FOR

SPINDLES AND TABLE INSERTS

This sander features on-board storage for three table inserts and four sanding spindles.

Storage for the sanding spindles can be found on the right side of the machine (See Figure 8) while storage slots for the table inserts are located on the left side.

For convenience and safety, keep all table inserts and sanding spindles that are not being used stored in their proper areas.

Figure 8

OPERATION

Failure to read and understand the instructions, warnings and safety guidelines provided in this manual may lead to serious

injury and / or damage to machine or the work piece.

Be sure the sanding spindle is securely installed in the machine.

Make sure the table tilt locking levers are secured and that the table is

locked in place at the desired angle or tilt.

Make sure the machine is installed on a flat, sturdy and stable surface able to support the weight of the machine and the work

piece to be sanded.

Select and install the desired sanding spindle with the corresponding table insert (see page 9).

Ensure the table is at the correct sanding angle and that the table position is locked in place.

To start the machine, remove the lock-out pin and push the green “START" button. Wait for the spindle to reach full speed before sanding.

Hold the work piece firmly and work from a stable standing position. When the table is fully horizontal (90°), you may sand from any part of the table. When the table is tilted, make sure the work piece is positioned on the front half of the table. (See Figure 9.)

To achieve the best finish results and to ensure maximum sanding sleeve life, slowly move the work piece back and forth across the entire surface of the sanding spindle

To stop the machine, push the red “Stop" button and wait for the spindle to come to a complete stop.

Figure 9

When you have finished using the machine be sure to re-install the lock-out pin and unplug the machine from the power source.

10

Page 10
Image 10
Delta 31-483 operating instructions Operation, ON-BOARD Storage for Spindles and Table Inserts