RECOMMENDED MAINTENANCE
NOTE: Disconnect machine from power source before performing any maintenance.
LUBRICATION
All bearings are sealed and permanently lubricated. No further lubrication is needed.
ROUTINE INSPECTION
It is recommended that you periodically inspect your spindle sander as a precautionary action. During this time, check for the following:
•Inspect all hardware, fittings and fasteners that may have loosened due to vibration and
•Check for dust and/or wood particles that may have accumulated on or in the machine. Check all dust collection fittings –
•Inspect the ON/OFF SWITCH for damage before each use. Periodically inspect the power cord and plug for damage. If necessary replace the power cord and the plug at the first signs of visible damage.
•Check all table inserts, spindles and sanding sleeves for damage and replace if necessary.
REPLACING THE SANDING SLEEVES
Make sure that the switch is in “OFF" position and that the power cord is unplugged.
NOTE: Reverse threads are used to attach the spindle to the machine.
•Remove the table insert by lifting it up and over the sanding spindle.
•Using two 17 mm wrenches, as shown in Figure 4 (page 8), loosen the spindle by turning it clockwise.
•With the 17 mm wrench still positioned on the spindle seat, unscrew (clockwise) the spindle with your hand and remove.
•To remove the ¼", ½", or 5/8" sanding sleeve, loosen the Phillips head screw at the bottom of the spindle and pull the sanding sleeve and spindle apart.
To remove the 1 ½" or 2" sanding sleeve, use the supplied 12 mm wrench to loosen (clockwise) the nut at the top of the spindle. Pull the sanding sleeve and spindle apart.
•To install a new sanding sleeve, follow the directions on page 8 (INSTALL SANDING SLEEVES ONTO SPINDLES).
ACCESSORIES
A complete line of accessories is available from your DELTA® Supplier, DELTA® Factory Service Centers, and DELTA® Factory Service Centers, and DELTA® Authorized Service Centers. Please visit our Web Site www. DeltaMachinery.com for an online catalog or for the name or your nearest supplier.
Since accessories other than those offered by DELTA® have not been tested with this product, use of such accessories could be hazardous. For safest operation, only DELTA® recommended
accessories should be used with this product.
WARRANTY
To register your tool for warranty service visit our website at www.DeltaMachinery.com.
Five Year Limited New Product Warranty
DELTA® will repair or replace, at its expense and at its option, any new DELTA® machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a DELTA® factory service center or authorized service station with proof of purchase of the product within five years and provides DELTA® with reasonable opportunity to verify the alleged defect by inspection. For all refurbished DELTA® product, the warranty period is 180 days. DELTA® will not be responsible for any asserted defect which has resulted from normal wear, misuse, abuse or repair or alteration made or specifically authorized by anyone other than an authorized DELTA® service facility or representative. Under no circumstances will DELTA® be liable for incidental or consequential damages resulting from defective products. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty is DELTA®’s sole warranty and sets forth the customer’s exclusive remedy, with respect to defective products; all other warranties, express or implied, whether of merchantability, fitness for purpose, or otherwise, are expressly disclaimed by DELTA®. For further detail of warranty coverage and warranty repair information, visit www.DeltaMachinery.com or call
LATIN AMERICA: This warranty does not apply to products sold in Latin America. For products sold in Latin America, see country specific warranty information contained in the packaging, call the local company or see website for warranty information.
12
