ASSEMBLY

STAND AND ELECTRICALS

If you purchased your machine with the optional steel stand and electricals, the stand is shipped as shown in Fig. 2. The switch (A) Fig. 2 and motor (B) Fig. 3 are completely assembled to the stand and the necessary wiring from the motor to the switch has been completed.

ASSEMBLING

MACHINE TO STAND

Place the machine on the stand with the arbor pulley over the opening (A) Fig. 4, on the top of the stand. The drive belt is shipped on the arbor pulley of the machine and must be inserted down through the opening (A). The disc end of the machine is to be positioned on the same end of the stand that the switch (B) Fig. 4, is located. Line up the four holes on the base of the machine with the four holes (C) in the top of the stand. Place a 3/8" flat washer on a 3/8"-16x3" hex head screw (D) Fig. 5, (two are shown), insert screw through the hole in the base of the machine and the hole in the top of the stand. Thread a 3/8"-16 hex nut onto the screw and tighten securely. Repeat this process for the three remaining holes.

A

Fig. 2

B

Fig. 3

BA

C C

Fig. 4

D

Fig. 5

6

Page 6
Image 6
Delta 31-552 instruction manual Assembly, Stand and Electricals, Assembling Machine to Stand