Delta 37-070 MAINTENANCE

MAINTENANCE

When it becomes necessary to replace the belt on your

jointer, proceed as follows:

1. DISCONNECT THE TOOL FROM THE POWER

SOURCE.

2. Remove screw (A) Fig. 43, using Allen wrench

supplied, and remove belt guard (B).

3. Loosen three screws (C) Fig. 44, to release belt

tension and remove belt (D) from pulleys.

4. Assemble new belt to the cutterhead and motor

pulleys. Press down on motor pulley (E) Fig. 44, to

tension belt and tighten three screws (C).

5. Replace belt guard (B) Fig. 44.

Fig. 43

Fig. 44

Contents

Main SAFETY RULES SAVE THESE INSTRUCTIONS. ADDITIONAL SAFETY RULES FOR JOINTERS CONNECTING TOOL TO POWER SOURCE POWER CONNECTIONS MOTOR SPECIFICATIONS GROUNDING INSTRUCTIONS EXTENSION CORDS OPERATING INSTRUCTIONS FOREWORD UNPACKING AND CLEANING MINIMUM GAUGE EXTENSION CORD DEFINITIONS OF JOINTING AND PLANING OPERATIONS Page ASSEMBLING FENCE ASSEMBLY INSTRUCTIONS Page ASSEMBLING CUTTERHEAD GUARD ASSEMBLING CUTTERHEAD LOCK FASTENING JOINTER TO SUPPORTING SURFACE STARTING AND STOPPING JOINTER OPERATING CONTROLS AND ADJUSTMENTS LOCKING SWITCH IN THE OFF POSITION VARIABLE SPEED CONTROL SPEED CONTROL CHART DEPTH OF CUT ADJUSTMENT FENCE ADJUSTMENTS Page ADJUSTING KNIVES CORD STORAGE CHIP AND DUST CHUTE PUSH BLOCKS JOINTING AN EDGE OPERATION PLACEMENT OF HANDS DURING FEEDING PLANING WARPED PIECES PLANING SHORT OR THIN WORK DIRECTION OF GRAIN MAINTENANCE BELT REPLACEMENT Delta Building Trades and Home Shop Machinery Two Year Limited Warranty PARTS, SERVICE OR WARRANTY ASSISTANCE ACCESSORIES Page PORTER-CABLE DELTA SERVICE CENTERS (CENTROS DE SERVICIO DE PORTER-CABLE DELTA)