Delta 37-070 instruction manual Chip and Dust Chute, Cord Storage

8.If the knives are set too high, the work will be gouged at the end of the cut, as shown in Fig. 33.

9.As a final check, run a piece of work slowly over the knives for 6 to 8 inches. The wood should rest firmly on both tables as shown in Fig. 34, with no open spaces under the finished cut.

CHIP AND DUST CHUTE

A chip and dust chute (A) Fig. 35, is provided on the outfeed end of the jointer base for efficient chip removal.

CAUTION: KEEP HANDS OUT OF CHIP AND DUST CHUTE AT ALL TIMES.

	MATERIAL
OUT-FEED	IN-FEED TABLE
TABLE

KNIVESCUTTER

SET TOO HIGH

GOUGE

Fig. 33

	MATERIAL
OUT-FEED	IN-FEED TABLE
TABLE
KNIVES AT	CUTTER
CORRECT HEIGHT
	Fig. 34

A

Fig. 35

CORD STORAGE

A cord storage bracket (A) Fig. 36, is provided on jointer base for storage of the cord when machine is not in use.

A

Fig. 36

15