2
Jetted Shower XO™ Trim Installation
A.
18 Series Installation - Single Unit
B.
1
1
ABC
2
34
5
Select proper label (1), the 3 position
label B (used with the blue stem
extender) or 6 position label C (used with
the black stem extender) and assemble
onto trim ring (2). (Refer to chart below
for proper label selection.) Slide trim ring
onto sleeve (3) until it bottoms out on the
escutcheon (4). Install handle (5) onto
stem, tighten set screw to secure. Thread
the bonnet assemblies (6) onto the jet
sleeve assemblies (7).
1
Jetted
Shower™
Jetted Shower
XO™
2 Ports 3 Ports
Stem
Extender White Blue Black
Label A B C
7
6
Thread sleeve (1) onto brass body, use
wrench to tighten. Place escutcheon (2)
over jet body module. Install screws (3).
Thread the jet sleeve assemblies (4) onto
the jet body module. Use the wrench (5) to
tighten the sleeve assemblies.
CAUTION: DO NOT OVERTIGHTEN.
TIGHTEN UNTIL THE ESCUTCHEON IS
FLAT AGAINST THE WALL.
C.
4
2
1
5
3
Turn off water supplies. Unscrew test
caps (1) from the body. If this is not a thin
wall mounting, the entire plasterguard may
be removed. IMPORTANT: NOTE COLOR
OF BASE ON STEM EXTENDER (2)
FOR USE LATER. (SEE CHART BELOW
FOR REFERENCE.)
12
2