ATTACHING MOTOR AND BLOWER ASSEMBLY TO
B
FRAME
A
A
1.Place motor assembly and base assembly on their side.
2.Align the four holes, two shown at (C), on the top of the side supports (A) Fig. 8, with the four holes in the motor assembly (B).
3.Place a 5/16" lockwasher onto a
4.Repeat this process for the three remaining holes.
5.Fig. 9 shows the motor and blower assembly attached to the side supports.
ASSEMBLING FIRM BOARD
1.Place the firm board (A) inside the two side supports
(B) Fig. 10. NOTE: MAKE SURE FIRM BOARD IS
ATTACHED TO THE SIDE SUPPORTS CLOSEST TO THE MOTOR.
2.Align the four holes in the firm board with the four holes in the side boards as shown in Fig. 10.
3.Insert a
4.Place a 5/16" lockwasher on the hex head screw.
5.Thread a 5/16" hex nut on the hex head screw and tighten securely.
6.Repeat this process for the three remaining holes for attaching the firm board.
7.Fig. 12 shows the firm board attached to the side supports.
A
C
Fig. 8
Fig. 9
B | A | B |
| ||
| Fig. 10 |
|
|
|
|
|
|
|
Fig. 11 | Fig. 12 |
6
