ASSEMBLY

ASSEMBLING WHEEL

CASTERS

1.Remove the hex nut and lockwasher from each of the four wheel casters.

2.Place the dust collector on its side.

2.Insert bolt from wheel caster through the four holes

(A) Fig. 3 in the base of the dust collector (three are not shown).

3.Place a lockwasher (A) Fig. 4 onto each bolt.

4.Thread hex nut (B) Fig. 4 onto each of the four bolts and tighten securely.

ASSEMBLING SIDE

SUPPORTS

1.Place the dust collector base (A) Fig. 5, in an upright position as shown.

2.Align the two holes in the bottom of side support (B) Fig. 5 with the two holes (A) in the base.

3.Insert a 5/16-18x3/4" hex head screw (A) Fig. 6 thru each hole in the side support and base.

4.Place a 5/16" lockwasher onto the hex head screw.

5.Thread a 5/16" hex nut onto the hex head screw and tighten securely.

A

Fig. 3

B

A

Fig. 4

B

A

Fig. 5

6.Repeat this process for the remaining side support.

7.Fig. 7 shows both side supports (A) attached to the base (B).

AA

A

B

Fig. 6

Fig. 7

5

Page 5
Image 5
Delta 50-775 instruction manual Assembly, Assembling Wheel Casters, Assembling Side Supports