Delta 50-786 ATTACH SIDE PANELS TO BASE (FIg. 58), ATTACH CROSS PANELS TO SIDE PANELS (FIg. 9, 10)

8
ATTACH SIDE PANELS TO BASE (FIg. 5–8)
1. Place5/16"lockwasher(K)on5/16"x3/4"(19mm)
hex head bolt (L).
2. Line up holes (M) in side panel (N) with holes (O) in
base plate.
NOTE: Be sure side panel is oriented as shown in
Figure6.
3. Placehexheadbolt andwasherassemblythrough
hole (M) in the side panel and and hole (O) in base.
4. From underneath the base secure side panel to
baseusinga5/16"hexnut(Q).
5. Repeat for other hole in side panel and base.
6. Repeatabove stepsforthe otherside panel.The
two panels are shown correctly assembled in
Figure8.
NOTE:FASTENALLHARDWAREHANDTIGHTONLYAT
THISPOINT.Hardwarewillbetightenedlaterinacertain
order.
ATTACH CROSS PANELS TO
SIDE PANELS (FIg. 9, 10)
1. Place5/16"lockwasher(K)(inset)ona5/16"x3/4"
(19 mm) hex head bolt (L).
2. Line up four holes of cross panel (R) with four lower
holes in side panels (N).
3. Insert hex head bolt and washer assembly - (L) and
(K) (inset) - through holes in side panels (N) and then
through holes in cross panel (R).
4. Attachcrosspaneltosidepanelusing5/16"hexnut
(Q).
5. Assembled cross panel is shown in Figure 11.
6. Assembletopcross panelin thesame mannerat
holes (SS).
NOTE:FASTENALLHARDWAREHANDTIGHTONLYAT
THISPOINT.Hardwarewillbetightenedlaterinacertain
order.
FIg. 5
FIg. 5
L
K
M
O
O
M
Q
FIg. 7
N
FIg. 6
FIg. 8
FIg. 9 L
K
R
N
N
Q
FIg. 10 FIg. 11
SS
SS