To Replace Belt

Serious injury or damage may occur if parts of the body or loose items get caught in moving parts. Never

operate the unit with the belt guard removed. The belt guard should be removed only when the compresor is unplugged.

1.Place the ON/AUTO-OFF lever in the OFF position.

2.Unplug compressor.

3.Remove the front of the belt guard by disengaging the snaps. Insert a flat bladed screwdriver at each snap location and pry the beltguard apart.

4.Loosen the wing nut on hold down plate and tilt motor to allow for easy removal or installation of the belt.

5.

Remove belt.

Wing Nut

 

6.

Replace belt. NOTE: The belt

 

must be centered over the grooves on the flywheel and motor pulley.

7.Turn the wing nut on the hold down plate until it makes contact

with the washer, plus one additional turn.

8.Replace the belt guard.

STORAGE

Before you store the air compressor, make sure you do the following:

1.Review the "Maintenance" section on the preceding pages and perform scheduled maintenance as necessary.

2.Set the On/Auto/Off lever to "OFF".

3.Close the globe valve.

4.Remove the air tool or accessory.

5.Open the globe valve and allow the air to slowly bleed from the air tank until tank pressure is approximately 20 psi.

6.Drain water from air tank by opening drain valve (counter-clockwise) on bottom of tank.

Water will condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture.

7.After the water has been drained, close the drain or drain valve.

NOTE: If drain valve is plugged, release all air pressure. The valve can then be removed, cleaned, then reinstalled.

8.Protect the air hose from damage (such as being stepped on or run over).

21-ENG

D26269

Page 21
Image 21
Delta 66-750 instruction manual Storage, To Replace Belt