STORAGE
This pressure washer should be stored in such a way to protect it from freezing. Do not store this unit outdoors or in an area where temperatures will fall below 32º F. This can cause extensive damage to this unit. Drain as much water as possible as follows:
1.Stop the pressure washer, detach the water hose, and pull the trigger on the spray handle to release the pressure in the inlet hose.
2.Restart the unit, pull the trigger, and run until water no longer sprays out of the nozzle. (Approximately 30 seconds)
3.Stop unit. Detach high pressure hose from unit. Leave hose attached to wand to protect it against accidental dropping. Pull trigger to drain water from wand and hose, and place assembly in storage.
*If unit has to be stored under freezing conditions a nontoxic R.V. antifreeze can be used to protect from freezing.
Add antifreeze as follows:
1.Make sure the unit is turned off, the water supply hose is disconnected,
Do not disconnect the high pressure hose or gun.
2.Tip the unit on end with the water inlet fitting pointing upward.
3.With the trigger depressed,
place the
4.With the motor running pour approximately 1/4 cup of nontoxic R.V. antifreeze into the water inlet (See Figure 12). Let unit run for a few seconds.
Figure 12
5.Turn the unit off and pull the trigger on the gun to relieve any pressure from the hose and gun.
6.After removing the high pressure hose, restart the unit to displace any water remaining in the pump.
11- ENG | D27665 |
