18.Align the two holes in the lamp bracket (A) Fig. 17, with the two holes (B) on the side of the drill press head.

19.Place the cord bushing (C) Fig. 17, around the top of the lamp cord (D).

20.Align the two holes in the lamp cord bracket (F) Fig.

18with the two holes in the lamp bracket (A) and drill press head.

21.Place a 1/4" washer onto a M6x1x12mm cap head screw. Insert the screw (G) Fig. 18 through the hole in the cord strain relief bracket and the lamp bracket and thread the screw into the drill press head. Repeat this process for the remaining hole in the cord strain relief bracket and tighten both screws securely.

A

B

C

D

Fig. 17

A

F

G

Fig. 18

22.Peel backing from cord clamp (H) Fig. 19, and apply clamp at the location shown. Make certain the lamp cord is routed out of the way of the drill, then secure cord (J) to cord clamp (H) as shown in Fig. 19.

H

J

Fig. 19

12

Page 12
Image 12
Delta DP400 instruction manual