For assembling stand:
21.
22. 5/16" Lock Washer (32)
23. 5/16" Flat Washer (32)
24.
To attach center to stand
25. 5/16 x 1/2" Hex Head Bolt (4)
26. 5/16" Lock Washer (4)
27.
28.#10 Flat Washers (4)
To attach motor to stand:
29. 1/2" Flat Washer (2)
30. 1/2" Locknut (2)
31.
32. 5/16" Lock Washer (2)
33. 5/16" Flat Washer (2)
34. 5/16" Wing Nut (2)
35.
36.Pointer and
37.Sanding Center
21 | 29 |
| |
22 | 30 |
23 | 31 |
| |
24 |
|
25 | 32 |
| |
26 | 33 |
| |
27 | 34 |
| |
28 | 35 |
36 |
|
Fig. 5
37 
UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
*Phillips Head Screwdriver (not supplied)
*11/16”, 3/4”, and 1/2” Socket or Open End Wrenches (not supplied)
ASSEMBLY TIME ESTIMATE -
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE OWNER’S MANUAL.
ASSEMBLING STAND
1.Attach the two short lower braces (A) Fig. 6, and the other two long lower braces (B) to the four legs (C), using the sixteen 5/8" carriage bolts, flat washers, lockwashers, and hex nuts. NOTE:Hand tighten the hex nuts for future adjustments.
2.Attach the top shelf (D) to the legs, using the remaining carriage bolts, flat washers, lockwashers, and hex nuts. NOTE: Hand tighten the hex nuts for future adjustments.
3.Make sure that the stand is on level ground. Use a helper to lift and position the machine on the top shelf, and tighten all stand hardware securely.
C
D
A
C
B
C
A
BC Fig. 6
9
