CHANGING ABRASIVE BELT
1.DISCONNECT MACHINE FROM POWER SOURCE.
2.Remove lock knob (A) Fig. 23, and remove side cover (B).
3.Depress tracking knob (C) Fig. 24, to release belt tension and remove belt (D) from the three wheels (E), as shown.
4.Install new belt and replace side cover. Check belt tracking by referring to the section “TRACKING THE
BELT”.
A
B
Fig. 23
E
C
D
Fig. 24
CHANGING SANDING DISC
1.DISCONNECT MACHINE FROM POWER SOURCE.
2Remove the two screws, one of which is shown (A) Fig. 25, and and remove the sanding disc guard and table (B).
3.Remove the used sanding disc (C) Fig. 26, from disc plate (D).
4.Make sure disc plate (D) Fig. 26, is clean.
5.Peel half of the backing from the new sanding disc. Press this half firmly in place. Remove the other half of the backing and press in place.
6.Replace sanding disc guard and table, that was removed in step 2.
B
A
Fig. 25
D
C
Fig. 26
10
