Delta PLC-5, SLC-500 KE Module Series a Switch Settings, KE Module Series B Switch Settings

Powerful Solutions for Digital Plants

Appendix A Module Settings

Appendix A discusses the necessary settings for 2 gateway modules. The 1785-KE module, Series A and B, and the 1771-KE and 1771-KF modules.

A.1	1785-KE Module (Series A) Switch Settings
	The 1785-KE module (Series A) has 6 switch assemblies which allow the selection of
	various communications options. The 1785-KE Module RS-232 parameters should be set
	up as follows:
	￿￿	Full duplex
	￿￿ Same parity as configured for the DeltaV PSIC Port
	￿￿	BCC error checking
	￿￿ Data Highway Plus communications baud rate of 57.6 K
	￿￿ RS-232C communications baud rate same as DeltaV PSIC port
	￿￿	Execute diagnostic commands
	There are additional switches on the 1785-KE module (Series A) which may require
	adjustment. Refer to the Allen-Bradley User Manual for further information.
	￿￿	SW1 - RS-232C link
	￿￿ SW2 - Not used (Switches must be off)
	￿￿	SW3/SW4 - Node Number
	￿￿ SW5 - Network link communication baud rate
	￿￿ SW6 - RS232C link communication rate and diagnostic commands

A.2	1785-KE Module (Series B) Switch Settings
	The 1785-KE (Series B) has 4 switch assemblies which allow the selection of various
	communications options. The 1785-KE Module RS-232C parameters should be defined
	as follows:
	￿￿	Full duplex
	￿￿ Same parity as configured for the DeltaV PSIC port
	￿￿	BCC error checking
	￿￿ Data Highway Plus communications baud rate of 57.6K
	￿￿ RS-232C communications baud rate same as configured for DeltaV PSIC port
	￿￿	Execute diagnostic commands

MYNAH Technologies ￿ 504 Trade Center Blvd. ￿ Chesterfield, MO 63005 ￿ Telephone 636 681-1555 ￿ Fax 636 681-1660

www.mynah.com

24