Manuals / Delta Electronics / Computer Equipment / Power Supply

Delta Electronics 700VA, 3KVA manual Annotation and symbol, Front Panel, Read before Operation

Models: 700VA 3KVA

1 31

Download 31 pages 34.64 Kb

Page 9

2-3 Annotation and symbol

2-3 Annotation and symbol

The two signs shown on the manual indicating important instruction need to be followed.

!

Read before Operation

Maybe Dangerous/Follow Instructions

PROTECTIVE GROUNDING TERMINAL: A terminal which must be connected to earth ground prior to making any other connection to the equipment.

This symbol indicates the word “phase”.

This symbol indicates the principal on/off switch is in the “ON” position.

This symbol indicates the principal on/off switch is in the “STANDBY” position.

2-4 FRONT PANEL

Operation p a n e l

Fig 2-1.1 Front Panel for 700VA or 1KVA

8

SHEET 9 TO 10

Image 9

Delta Electronics 700VA, 3KVA manual Annotation and symbol, Front Panel, Read before Operation

Contents

SHEET 1 TO 1-1 UL safety instructions 1. IMPORTANT SAFETY INSTRUCTIONSSHEET 3 TO Other safety notes1-2 TUV safety instructions For installationOther safety instructions EC conformity declaration 2-1 Theory of operation 2 INTRODUCTIONHigh power density 2-2 FeaturePFC Power Factor Correction Complete ProtectionIntelligent design Safety approvalsConsiderate design Green function design2-3 Annotation and symbol 2-4 FRONT PANELRead before Operation 2-5 OPERATION PANEL B B A BOPERATION PANEL 3. ON Line The UPS is running in “ON-LINE mode” The rear panel is explained as follows Please refer to fig 2-3 2.6 REAR PANELFig 2-3 700VA, 1KVA Fig 2-4 2KVA, 3KVA2. I/P BREAKER This is used to prevent high input current from the UPS 3-2 Before Installation 3. INSTALLATION3-3 Installation 1. Connecting to utility power Refer to fig If input type is terminal type 2. Checking the site wiring fault LED If the function is available3. Charging the battery 4. Connecting the loadConnecting the battery bank 5. Connecting the RS-232/Dry contact SHEET 18 TO Fig 3-4.2 UPS Connection for 2KVA or 3KVA4. OPERATION 4-1 Cold start when utility is not present4-2 Turning “ON” the UPS 4-3 Turning “OFF” the UPS4-5 Silence function 4-4 UPS self-testFig 4-7 Battery Replace 4-9 Derating power 4-7 UPS internal fault4-8 Storing the message into EEPROM 4-10 Programmable output Optional5. MAINTENANCE 6. PLACEMENT Fig 6-1 Erect the UPS with supporting standsSHEET 24 TO Problem 7. TROUBLESHOOTINGSolution Possible Cause“FAULT”LED lights on FAULT MESSAGEalarm beeps UPS failure8-1 RS-232 8. COMMUNICATION INTERFACEBAUD RATE 8-2 Dry ContactDATA LENGTH STOP BITIts major functions normally some or all of following Battery Technical specificationsSHEET 30 TO ModelSHEET 31 TO END