ENGLISH
Setting the delay time
•Input the distance between the listening position and the different speakers to set the delay time for the surround mode.
•The delay time can be set separately for surround speakers A and B.
6 | Set the distance between the |
center speaker and listening |
position.
The distance changes in units of 0.1 meters (1 foot) each time the button is pressed.
Preparations:
Measure the distances between the listening position and the speakers (L1 to L5 on the diagram at the right).
L1: Distance between center speaker and listening position
L2: Distance between front speakers and listening position
L3: Distance between surround speakers and listening position
L4: Distance between surround back speaker and listening position
L5: Distance between subwoofer and listening position
FL | Center | FR | |
Subwoofer | L1 | L2 |
|
| L5 |
| Listening position |
SL | L3 | L4 | SR |
|
|
| SB |
Select the value closest to the measured distance.
Example: When the distance is set to 3.6 m for the center speaker
If “Yes” is selected for “Default”, the settings are automatically reset to the default values.
Please note that the difference of distance for every speaker should be 4.5 m (15 ft) or less. If you set an invalid distance, a CAUTION notice, such as screen right will appear. In this
1 | At the System Setup Menu select “Delay Time”. |
|
2 | Switch to the Delay Time screen. |
| ENTER |
3 | Select the desired unit, meters or feet. |
Select (darken) the desired units, “Meters” or “Feet”. |
Example: When “Meters” is selected
4 | Once “Meters” or “Feet” is selected in Step 3, |
the Delay Time screen appears automatically. |
5 | Select the speaker to be set. |
|
case, please relocate the blinking speaker(s) so that its distance is no larger than the value shown in highlighted line.
7 | Enter the setting. |
ENTER | |
The System Setup Menu reappears. |
The
NOTE:
•If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 9).
Setting the channel level
•Use this setting to adjust so that the playback level between the different channels is equal.
•From the listening position, listen to the test tones produced from the speakers to adjust the level.
•The level can also be adjusted directly from the remote control unit. (For details, see page 24.)
1 | At the System Setup Menu select “Channel Level”. |
|
2 | Switch to the Channel Level screen. |
| ENTER |
3 | Select “Test Tone Mode”. |
|
12