Basic Operation
Using the fader function
With this function, the volume of all the front side speakers or all the rear side speakers can be adjusted (attenuated) at once.
1 Press CH SEL/ENTER.
2 Press D H or CH SEL/ENTER to select “Fader”.
3 Press F to attenuate the volume of all the front side speakers, G to attenuate the volume of all the rear side speakers.
The fader function does not affect the subwoofer.
It is possible to adjust so that the volume of the speaker whose volume is the lowest is
2
3
Listening to the radio
Check that the remote control unit is set to “AMP”.
Auto tuning
1 Either turn <FUNCTION> or press [TUNER] to select “TUNER”.
2 Press [BAND] to select “AM” or “FM”.
3 Press [MODE] to set the auto tuning mode.
• The “AUTO” indicator lights.
4 Press [TUNING].
• Automatic searching begins.
• If tuning does not stop at the desired station, use to the “Manual tuning” operation.
Manual tuning
1 Either turn <FUNCTION> or press [TUNER] to select “TUNER”.
2 Press [BAND] to select “AM” or “FM”.
3 Press [MODE] to set the manual tuning mode.
Check that the display’s “AUTO” indicator turns off.
4 Press [TUNING] to tune in the desired station.
The frequency changes continuously when the button is held in.
•When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO” indicator turns off.
ENGLISH
Basic Operation
Preset memory
1 Use the “Auto tuning” or “Manual tuning” operation to tune in the station to be preset in the memory.
2 Press [MEMORY].
3 Press [SHIFT] to select the desired memory block (A to G).
4 Press [CHANNEL] to select the desired preset channel (1 to 8).
5 Press [MEMORY] again.
• Store the station in the preset memory.
• To preset other channels, repeat steps 2 to 5.
A total of 56 broadcast stations can be preset — 8 stations (channels 1 to 8) in each of blocks A to G.
• The memory block can also be selected by pressing [SHIFT].
35
ENGLISH