Getting Started

Before using

Pay attention to the following before using this unit:

•Moving the unit.

To prevent short-circuits or damaged wires in the connection cables, always unplug the power supply cord and disconnect the connection cables between all other audio components when moving the unit.

•Cautions on using mobile phones.

Using a mobile phone near this unit may result in noise. If so, move the mobile phone away from this unit when it is in use.

•Before turning the power operation button on.

Check once again that all connections are correct and that there are not problems with the connection cables. Always set the power operation button to the standby position before connecting and disconnecting connection cables.

•Store the operating instructions in a safe place.

After reading the operating instructions, store them in a safe place as they could come in handy in the future.

•Whenever the power operation button is in the STANDBY state, the unit is still connected to AC line voltage.

Please be sure to turn off the power switch or unplug the cord when you leave home for, say, a vacation.

•Note that the illustrations in these instructions may differ from the actual unit for explanation purposes.

Cautions on installation

Note:

For heat dispersal, do not install this unit in a confined space such as a bookcase or similar enclosure.

Note

About the remote control unit

In addition to controlling the DRA-697CI, the attached system remote control unit (RC-1052) can also be used to control the following products:

qDENON component products

wComponent products other than DENON:

• Set using the preset memory function ( page 22).

Inserting the batteries

qRemove the remote control unit’s rear cover.

(RC-1052)

(RC-1056)

wSet two batteries in the battery compartment in the indicated direction.

R6P/AA

R03/AAA

 

(RC-1052)

(RC-1056)

ENGLISH

Getting Started

Notes on batteries:

•Replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the unit. (The attached batteries are only for verifying operation.)

•When inserting the batteries, be sure to do so in the proper direction, following the “<” and “>” marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•Remove the batteries from the remote if it will not be in use for long periods.

•When replacing the batteries, have the new batteries ready and insert them as quickly as possible.

Operating range of the remote control unit

•Point the remote control unit at the remote sensor when operating it.

•The remote control unit can be used from a distance of approximately 23 feet/7 meters, at a horizontal angle of up to 30° with respect to the sensor.

30°

30°

or

Approx. 23 feet/7 m

(RC-1056)

(RC-1052)

Wall

2

NOTE:

•The set may function improperly or the remote control unit may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light.

ENGLISH