5 TROUBLESHOOTING

Check the following before assuming there is a problem with the set.1.Are all connections proper ?2.Is the set being operated as described in the operating instructions ?3.Are the speakers and input components being operated properly ?

If the set does not seem to be operating properly, check the points listed below. If these points do not apply, the set may be damaged. Turn off the power immediately and contact your store of purchase.

 

 

Symptom

Cause

Measures

Page

 

 

 

 

 

 

 

 

MUTE/STANDBY LED does not

• Power supply cord is not connected.

• Check that the cord is plugged in.

8

CD,

 

light and no sound is produced

 

 

 

 

when POWER switch is turned

 

 

 

to the

 

on.

 

 

 

 

 

 

 

 

 

 

• Speaker cords not properly

• Connect securely.

7, 8

arising when listening

 

 

FM broadcasts, etc.

MUTE/STANDBY LED lights but

connected.

 

 

• INPUT SELECTOR is not set to

• Set to the proper position.

5, 9

no sound is produced.

proper position.

 

 

 

 

 

 

• VOLUME control turned down.

• Set to an appropriate level.

5, 9

 

 

 

 

 

• Speaker cords not properly

• Connect securely.

7, 8

Sound is not produced from one

connected.

 

 

• Input cords not are properly connected.

• Connect securely.

8

side only.

Common problems

records, tapes, and

• Left/right balance improperly

• Adjust the BALANCE control.

5, 9

 

 

adjusted.

 

 

 

 

 

 

Volume level is different when

• Tuner or record output is different.

• Adjust the tuner output to the

 

turntable’s output (if the tuner is

 

listening to tuner and records.

 

 

 

equipped with an output control).

 

 

 

 

 

 

 

 

Positions of instruments inverted

• Left and right speakers or input cords

• Check the left/right connections.

7, 8

 

 

 

 

for stereo sources.

the inverted.

 

 

 

 

 

 

 

 

 

 

 

• Turntable’s ground wire is not

• Connect securely.

8

records.

 

connected.

 

 

Booming sound produced when

• Input cords are not properly

• Connect securely.

8

playing records.

connected to PHONO terminals.

 

 

 

• Influence from a TV or VCR near the

• Change the position of installation.

playing

 

 

turntable.

 

 

 

 

 

 

 

• Turntable and speaker systems are

• Move speaker systems as far away

when

 

 

too close.

as possible.

 

 

• Floor is soft and vibrates easily.

• Use cushions to absorb the vibrations

occurring

Howling produced when volume

 

transmitted from the floor to the

 

is turned up while playing records.

 

 

 

speakers. If the turntable does not

 

 

 

 

 

 

include insulators, use audio

 

Problems

 

 

insulators, available in stores.

 

 

 

 

 

 

• Stylus pressure is too light.

• Apply proper pressure.

Sound is distorted.

• Dirt on tip of stylus.

• Check the tip of the stylus.

 

 

 

• Defective cartridge.

• Replace the cartridge.

 

 

 

 

 

 

unit.

 

• Batteries are dead.

• Replace with new batteries.

10

 

• Remote control unit is too far from

• Move closer.

10

control

 

this unit.

 

 

This unit is not operated properly

• Obstacle between this unit and

• Remove obstacle.

10

when remote control unit is used.

remote control unit.

 

 

Remote

 

 

 

• Different button is being pressed.

• Press the proper button.

11

 

<and >ends of battery is inserted

• Insert batteries properly.

10

 

in reverse.

 

 

 

 

 

 

 

 

 

 

 

 

 

12