8
ENGLISH ENGLISH
2CONNECTIONS

Connecting the speakers

•Speaker impedance
•Use speakers with an inpedance of 4 to 16 Ω/ohms.
•The protective circuit may be activated if speakers with
other impedances are connected.
•Be sure to connect the cords between the speaker terminals
and speaker systems with the same polarities (<to <, >to
>). If not, the central sound will be weak and the position of
the different instruments will not be clear, diminishing the
stereo effect.
•When connecting the speakers, be sure that the conductors of
the speaker cords do not stick out from the terminals and
touch other terminals, each other or the rear panel.
•Connecting the speaker cords
qPeel off the sheathing from the end of the cord.
wTwist the conductors.
eTurn the speaker terminal counterclockwise to loosen it.
rInsert the conductors of the cord entirely, then turn the
terminal clockwise to tighten it.

CAUTION

Protective Circuit
This set is equipped with a high speed protective circuit.
This circuit protects the internal circuitry from damage due
to large currents flowing when the speaker terminals are not
completely connected or when an output is generated by a
short circuit. This protective circuit’s operation cuts off the
output to the speakers. In such a case, be sure to turn the
power off and check the connections to the speakers. Then
turn the power on again. After muting for several seconds,
the set will operate normally.
NOTE:
NEVER touch the speaker terminals when the power is on.
Doing so could result in electric shocks.
Speaker terminal
Speaker cord
Twist the conductors or
terminal processing is
carried out.