132
Execution program not selected
■Problem
No user program has been selected as an execu-
tion program to be run when the power is turned
on.
If this error occurs, the BHT beeps five times
(for 0.1 second per beep) and then turns itself
off.
■Solution
Run System Mode and select an execution pro-
gram in the SET SYSTEM menu. (For the selecting
procedure, refer to Chapter 2, Subsection 2.5.3,
[4.1].)
Resume data lost
■Problem
No resume data has been retained since the BHT
was not normally turned off and then left with no
battery cartridge loaded or with a discharged bat-
tery cartridge loaded even if the resume function
had been set to ON.
The BHT displays this error message for 3
seconds and automatically runs the execution
program from the point of start-up.
Error in System Mode settings
■Problem
Your settings made in System Mode contain an er-
ror.
•If this error occurs, the System Mode
settings revert to the factory defaults.
•The BHT displays this error message for
three seconds and then displays the "No
execution program selected…" message.
■Solution
Make your settings in System Mode again.