Denso CLASSIC PLUS 14 COOL Mode, Temperature Control, Fan Mode Control DIP Switch, OPERATION cont

OPERATION (cont.)

Operating Modes

Both Classic Plus models operate in 2 modes, FAN Only and COOL. When in FAN Only mode the unit circulates the surrounding air. When in COOL mode, the compressor is engaged and cool air is circulated.

■COOL Mode

Both models will operate in FAN Only mode for approximately 120 seconds before the compressor engages (compressor time delay program is 120 + 10 seconds).

■Temperature Control

The room temperature thermistor allows the unit to switch auto- matically between COOL and FAN Only modes. This is dependent upon inlet air temperature versus SET POINT temperature.

■Fan Mode Control DIP Switch

The Fan Mode Control DIP Switch determines whether the FAN will continue to operate or stop when the compressor cycles off. (SET POINT temperature equals inlet air or room temperature.) The unit has been preset at the factory for continuous fan operation.

■Temperature Scale Display DIP Switch

The Temperature Scale Display DIP Switch changes the SET POINT temperature that is displayed to either °C or °F. The unit has been preset from the factory to display the SET POINT temperature in °F.

NOTE: If you wish to change the fan mode operation

(COOL￿OPERATE to COOL￿STOP), and/or the Temperature Scale Display (°F to °C), contact your MovinCool reseller.

11