Denso CU-7011 6.2 Interface Cable Connection

6.2 Interface Cable Connection

Connect the modular plug* of the Ethernet cable to the Ethernet port of the CU-7011.

(*10Base-T 8-pin modular, RJ45, ITA/ETA category 3 or higher)

Lock lever

Ethernet cable

•When connecting the modular plug, insert it until it snaps into place. To

disconnect it, press the lock lever and pull it out.

•Do not force the modular plug in or out. Doing so will result in a CU-7011

failure.

Contents

Main Page Page How this book is organized Page WARNING CAUTION Meaning of Symbols WARNING Handling the battery cartridge SAFETY PRECAUTIONS Be sure to observe all these safety precautions. Handling the CU WARNING Handling the battery cartridge Handling the CU CAUTION Proper Care of the CU Limited Warranty on Software Products Content Overviews Chapter 1 Ethernet System Configu- ration Chapter 2 Functions of the CU-7011 Chapter 3 Components and Functions Place the CU on a flat, horizontal plane. Do not install the CU on a wall or in a vertical position. Chapter 4 CU Status Indication by LED Indicators WARNING CAUTION Chapter 5 Applying Power to the CU-7011 Chapter 6 Connecting to Ethernet 6.1 Setting the Transmission Speed of the CU-7011 6.2 Interface Cable Connection 6.3 Communication with the Host Computer Chapter 7 Charging the Rechargeable Battery Cartridge Charging Operation and BHT's Indicator LED Page Page Appendix Specifications [ 1 ] Product Specifications [ 2 ] Charging Requirements [ 3 ] Interface