SPLIT OAK AND AMERICAN OAK DESIGN 18", 24" AND 30" MODELS
PRODUCT IDENTIFICATION
Top Middle Log
Left
Front
Branch
Piezo
Ignitor
Front
Burner
Right Front
Branch
Control Knob
Figure 1 - Split Oak Design Model
Front Log
Left Front
Branch
Piezo
Ignitor
Front
Burner
Base Assembly
Control Knob
Figure 2 - Standard Oak Design Model
Crossover Log
Rear Log
Rear
Burner
Bottom
Middle Log
Base Assembly
Crossover Log
Rear Log
Rear
Burner
Right Front
Branch
LOCAL CODES
Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANSI Z223, also known as NFPA 54*.
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Note: Where listed vented decorative logs are required, thermostat operation is not permitted.
UNPACKING
1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by burners. This could damage heater. Always handle base assembly by grate.
2.Remove all protective packaging ap- plied to logs and heater for shipment.
3.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought heater.
PRODUCT
FEATURES
Operation
This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing coals. This heater is designed for
Safety Device
This heater has a pilot with an Oxygen Depletion Sensor Shutoff System (ODS). The ODS/pilot is a required feature for vent- free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.
Piezo Ignition System
This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.
103426 | 3 |
