INTERNATIONAL
INSTALLATION INSTRUCTIONS
FOR
CONVERSION KIT
NATURAL GAS TO PROPANE/LP GAS
For Use When Converting Models BDV37N Series
This conversion kit must be installed by a qualified service agency.
Read these instructions completely before installing this conversion kit.
Before proceeding, make sure the gas control valve is in the “OFF” position, all electrical power to the appliance is OFF, and the fireplace is cool to the touch.
CAUTION: The gas supply shall be shut off prior to disconnecting the electrical power before proceeding with the conversion.
Parts included with this kit:
Part No. | Description | Quantity |
| Instruction Sheet | 1 |
Pilot Orifice | 1 | |
Burner, Propane/LP | 1 | |
Main Burner Orifice (1.32mm) | 1 | |
Gas Valve Regulator | 1 | |
Conversion Label, English | 1 | |
Conversion Label, French | 1 | |
Conversion Information Label | 1 |
Tools Required |
|
• 10mm Open End Wrench | • Torx T20 or Slotted Screwdriver |
• 12mm Open End Wrench | • 3/8" Socket or Nut Driver or |
• 5/16" Socket or Nut Driver | Slotted Screwdriver |
• 18mm Open End Wrench or | • #2 Phillips Screwdriver |
Adjustable Wrench | • High Temperature Silicone Sealant |
• 3/4" Open End Wrench or | (GE RTV 106/Loctite RTV 81585) |
Adjustable Wrench | • Thread Sealant (Resistant to Propane/LP) |
• 7/8" Open End Wrench or |
|
Channel Lock Pliers |
|
If any of these pieces are missing or damaged, contact the dealer where you purchased this kit or DESA International at
REMOVING GLASS DOOR
1.Remove the upper louver panel by lift- ing upward and out (see Figure 1).
2.Using a 3/8" socket or slotted screw- driver remove the screws from the three tabs at the top of the glass door (see Figure 2, page 2). Hold glass door se- curely to keep it from falling forward.
3.Grasp door by both sides and ease it upward off the lower bracket (see Fig- ure 2, page 2).
Top Louver Panel
Figure 1 - Removing Top Louver Panel
