OWNER’S MANUAL
PUMP ROTOR
(Procedure if rotor is binding)
1.Remove upper shell (see page 7).
2.Remove filter end cover screws using 5/16"
3.Remove filter end cover and air filters.
4.Remove pump plate screws using 5/16"
5.Remove pump plate.
6.Remove rotor, insert, and blades.
7.Check for debris in pump. If debris is found, blow out with compressed air.
8.Install insert and rotor.
9.Check gap on rotor. Adjust to
.076/.101 mm (.003"/.004") if needed (see Figure 17).
Note: Rotate rotor one full turn to insure the gap is .076/.101 mm (.003"/.004") at tight- est position. Adjust if needed.
10.Install blades, pump plate, air filters, and filter end cover.
11.Replace fan guard and upper shell.
12.Adjust pump pressure (see page 7).
Note: If rotor is still binding, proceed as follows.
13.Perform steps 1 through 6 above.
14.Place fine grade sandpaper (600 grit) on flat surface. Sand rotor lightly in “figure 8” motion four times (see Fig- ure 18).
15.Reinstall insert and rotor.
16.Perform steps 10 through 12 above.
Pump
Blade Plate Air Intake
Filter
Filter End
Cover
Insert
| Rotor |
100 | PFA/P 059A |
| Air Output |
| Filter |
Fan Guard
Figure 16 - Rotor Location
Gap Adjusting Screw
Blade
| .003"/.004" | |
| Gap | |
| Measured | |
Rotor | With | |
Feeler | ||
| ||
Gap Adjusting Screw | Gauge | |
| ||
Figure 17 - Gap Adjusting Screw | ||
Locations |
| |
Sandpaper |
| |
Figure 18 - Sanding Rotor
SPECIFICATIONS
Output Rating (Btu/Hr.) | 150,000 | |
Fuel | Use Only Kerosene | |
| or No. 1 Fuel Oil | |
Fuel Tank Capacity |
|
|
(Liters/U.S. Gal.) |
| 51/13.5 |
Fuel Consumption |
|
|
(Liters/Gal. Per Hr.) |
| 4.1/1.1 |
Electric Requirements |
| 110V/50Hz |
Amperage (Normal Run) | 4.4 | |
Hot Air Output |
|
|
(CMM/CFM) |
| 14.2/500 |
Motor RPM |
| 2850 |
Motor HP |
| 1/4 |
Approximate Shipping Weight
(KG/Pounds)31/68
Approximate Heater Weight without Fuel (KG/Pounds) 26/57
REPLACEMENT PARTS AND ACCESSORY
Purchase accessories and parts from your local dealer.
AIR GAUGE KIT - HA1180
Special tool to check pump pressure.
104001 | 9 |
