3.Test functions.
Temporarily position chime and push button where you want them mounted. Press push button to verify chime and push button work properly. If chime does not sound, see Troubleshooting.
4.Adjust volume.
The chime is equipped with a High/Low switch located on the left side. Slide the switch to either High or Low to adjust volume.
5.Mount push button and chime.
Use either a screw or double sided tape to mount push button.
To mount with screw, determine where push button will be located. Using 3/ 16" drill bit, drill tap hole. If screw is not mounted directly into wood stud or trim molding, use drywall anchor. Insert screw leaving approximately 1/8" gap between head of screw and wall. Place keyhole slot on rear of push button over the screw’s head and slide down firmly.
When attaching push button using double sided tape, make sure the surface is clean.
Chime can be mounted by using 1 screw with keyhole (see illustration on page 1) or placed on top of a desk or table. Follow steps under mounting push button with screw to mount chime.
STOP | Before returning product to store, please see Troubleshooting section |
| or call Technical Service toll free: |
