Code and Tune Settings
Code Settings
Note: Most installations will not require you to change any jumpers on your chime and push button.
This manual includes operating instructions for different types of chimes. All chimes work on the same principle and use the same channel setting infor- mation. Please read all instructional information and note any specific infor- mation pertaining to your particular chime.
The push button and chime communicate by using a code that can be changed by removing and/or adding jumpers on both the push button and chime. The code is factory set; however, there are selectable codes that allow you to expand your system and prevent outside interference (Models
1.To access the jumpers, remove the battery covers and locate the jumpers on both the push button and chime (See illustration on page 3). Note: To access the jumpers on the push button, the batteries must be removed.
2.The push button and chime both have multiple jumpers (either 3 or 7 de- pending on model). The jumpers are used for setting the code.
3.To change the code, add and/or remove jumpers as needed. It is recom- mended to only change one jumper at a time and then check to see if system is functioning properly. Note: Jumpers must be exactly the same for both the push button and chime for this system to function.
Inside Chime
REC.
Push Button Batteries
Replacement
Install 4 alkaline AA 12 Volt batteries. The positive terminal should be positioned as shown.
1 2 3 4 5 6 7
7 6 5 4 3 2 1
*Jumper Settings Must Match Both Push Button and Chime
REC.
Inside Push
Button
Note: Some models might require the use of tweezers to remove and replace the jumpers.
