Desa 5525 Test And Adjustment, Specifications, On-Timerange, Bottom of Sensor, Maximum Range

Models: 5525

1 8
Download 8 pages 34.14 Kb
Page 3
Image 3
TEST AND ADJUSTMENT
Aim Sensor
Higher for Long
Coverage

TEST AND ADJUSTMENT

Turn on the circuit breaker and light switch.

NOTE: Sensor has about 1 1/2 minutes warm up period before it will detect motion. When fi rst turned on, wait about 1 1/2 minutes.

Turn the RANGE control to the mid position and the ON-TIME control to the TEST position.

ON-TIMERANGE

10 5 1 TEST

MIN MAX

Bottom of Sensor

Avoid aiming the control at:

Objects that change temperature rapidly, such as heating vents and air conditioners. These heat sources could cause false triggering.

Areas where pets or traffic may trigger the control.

Nearby large, light-colored objects refl ecting light may trigger the shut-off feature. Do not point other lights at the sensor.

180°

8ft.

(2.4 m)

70 ft.

(21 m)

Maximum Range
Maximum

 

Coverage Angle

The detector is most sensitive to motion across its fi eld of view.

Loosen the clamp screw in the

Clamp

sensor ball joint and gently

Screw

rotate the sensor.

 

Walk through the coverage area

Ball

noting where you are when the

Joint

lights turn on (also, the LED will

 

flash several times when motion

 

is detected). Move the sensor

 

head up, down, or sideways to

 

changethecoveragearea.Keep

Aim Sensor
the sensor at least 1" (2.5Down for Short
cm) away from the lamp.Coverage

Adjust the RANGE as needed. RANGE set too high may

increase false triggering.

Secure the sensor head by tightening the clamp screw. Do not overtighten the screw.

Set the amount of TIME you

want the lights to stay on after motion is detected (1, 5, or 10 minutes).

SPECIFICATIONS

Range . . . . . . . . . . . . . Up to 70 ft. (21 m) [varies with surrounding temperature].

Sensing Angle . . . . . . . Up to 180°

Electrical Load. . . . . . . Up to 250 Watts Maximum Incandescent.

Power Requirements . . 120 VAC, 60 Hz

Operating Modes . . . . . TEST, AUTO and MANUAL

MODE

Time Delay . . . . . . . . . 1, 5, 10 minutes Replacement lamp. . . . T3, 250W (or less) halogen

120 VAC

DESA Specialty Products reserves the right to dis- continue products and to change specifications at any time without incurring any obligation to incorporate new features in products previously sold.

Motion

Motion

 

Sensor

Least Sensitive

Most Sensitive

598-1311-00

3

Page 3
Image 3
Desa 5525 Test And Adjustment, Specifications, On-Timerange, Bottom of Sensor, Maximum Range, Motion, Least Sensitive