Desa VS30NRA, VS24NRA Product Identification, Product Features, Local Codes, Unpacking, Operation

OWNER’S MANUAL

PRODUCT IDENTIFICATION

PRODUCT

FEATURES

Crossover Log

OPERATION

Front Log

Front

Burner

Piezo

Ignitor

	HI
MAN	TEMP
AUTO	LO
	ON
	OFF

Rear Log

Rear

Burner

Middle

This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney. Heat is generated by both realistic flames and glowing coals. This heater is designed for vent-free opera- tion with flue damper closed. It has been tested and approved to ANS Z21.11.2 stan- dard for unvented heaters. State and local codes in some areas prohibit the use of vent- free heaters. This heater may also be oper- ated as a vented decorative (ANS Z21.60) product by opening the flue damper (non- thermostat operation only).

SAFETY PILOT

STATUS
	Control Knob
Remote	Flame
Control
(Optional)	Adjustment
	Knob

Selector

Log

Base Assembly

This heater has a pilot with an Oxygen Detection Safety Pilot System (ODS). The ODS/pilot is a required feature for vent-free room heaters. The ODS/pilot shuts off the heater if there is not enough fresh air.

PIEZO IGNITION SYSTEM

Figure 1 - VS24NR Shown

Switch (Optional)

This heater has a piezo ignitor. This system requires no matches, batteries, or other sources to light heater.

LOCAL CODES

Install and use heater with care. Follow all local codes. In the absence of local codes, use the latest edition of The National Fuel Gas Code ANS Z223.1, also known as NFPA 54*.

*Available from:

American National Standards Institute, Inc.

1430 Broadway

New York, NY 10018

National Fire Protection Association, Inc.

Batterymarch Park

Quincy, MA 02269

Note: Where listed vented decorative logs are required, thermostat operation is not permitted.

UNPACKING

CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.

1.Remove logs and heater base assem- bly from carton. Note: Do not pick up heater base assembly by burners. This could damage heater. Always handle base assembly by grate.

2.Remove all protective packaging ap- plied to logs and heater for shipment.

3.Check all items for any shipping dam- age. If damaged, promptly inform dealer where you bought heater.

OPTIONAL REMOTE CONTROL ACCESSORIES

There are four optional remote controls that can be purchased separately for this log heater:

•wall switch

•wall thermostat

•hand-held ON/OFF remote

•hand-held thermostat remote.

See Accessories, page 25.

The wall thermostat or hand-held thermo- stat may not be used where vented decora- tive listing is required.

104416 3