CLEANING AND
MAINTENANCE
Continued
Most halogen light bulbs are rated to last approxi- mately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice or more of the following:
•Flame is dim or dark in certain areas
•Log set ember bed appears dim or dark in certain areas
WARNING: Do not install replacement bulbs that exceed specified maximum watts.
8.Secure the rear cover of the unit to the main frame by reattaching the 6 screws remove in step 1.
Screws
Screws
Figure 5 - Screw Locations
Figure 4 - Replacement Light Bulb
Your unit must be opened in order to replace the light bulbs. To reduce the number of times you need to open the unit, replace all bulbs at the same time if they are close to the end of their rated life.
Tools Required: Phillips Screw Driver
Replacing Flame Generation Bulb
1.Unplug unit from the power supply.
2.Remove the six screws from the back of stove as shown in Figure 5. Remove back plate.
3.Locate the flame generation cylindrical drum (see Figure 6). It is constructed of two removable halves. They are two matte black
4.Squeeze half of drum cylinder until its top edge clears the top drum track. Remove the bottom edge of the cylinder drum from the bottom drum track. This will give you access to the light bulbs. Note: Do not exert exces- sive pressure on the drum cylinder as this may cause damage.
5.Remove spring clip. Hold socket and pull out old bulb.
6.Hold socket and push in new bulb. Replace spring clip.
7.Insert bottom edge of removed cylinder half into bottom of drum track. Gently squeeze drum cylinder until it's top edge fits into top drum rack.
Cylinder
Flame
Generation
Bulb
Ember Bed
Bulb
Figure 5 - Cylinder and Bulb Locations
Replacing Ember Bed Bulbs
1.Unplug unit from the power supply.
2.Remove the six screws from the back of stove as shown in Figure 5. Remove back plate.
3.Locate the ember bed light bulb in the bottom of the unit shown in Figure 6. It is under the flame generation cylindrical drum toward the front of the unit.
4.Remove spring clip. Hold socket and pull out old bulb.
5.Hold socket and push in new bulb. Replace spring clip.
6.Secure the rear cover of the unit to the main frame by reattaching the 6 screws remove in
step 1.
www.desatech.com | 5 |
