INSTALLING |
| NOTICE |
| ||
TO WALL |
|
| |||
| A qualified service person must install heater. Follow all local codes. |
| |||
|
|
|
|
| |
CHECK GAS TYPE |
|
|
| ||
Use only propane gas. If your gas supply is not propane, do not install heater. Call | |||||
dealer where you bought heater for proper type heater. | |||||
INSTALLATION ITEMS |
|
|
| ||
Before installing heater, make sure you have the items listed below. | |||||
• | external regulator (supplied by | • | ground joint union | ||
|
| installer, see page 14) | • | test gauge connection * (see | |
• piping (check local codes) |
| Figure 13, page 15) | |||
• | sealant (resistant to propane gas) | • | sediment trap | ||
• manual shutoff valve * | • tee joint | ||||
|
|
| • pipe wrench | ||
* An A.G.A. design certified manual shutoff valve with 1/8" NPT tap is an acceptable | |||||
alternative to test gauge connection. Purchase the optional A.G.A. design certified | |||||
manual shutoff valve from your dealer. See Accessories, page 27. | |||||
LOCATING HEATER
This heater is designed to be mounted on a wall.
WARNING
Maintain the minimum clearances shown in Figure 4 (page 10). If you can, provide greater clearances from floor, ceiling, and joining wall.
You can locate model CGP18B on floor, away from a wall. An optional floor mounting stand is needed. Purchase the floor mounting stand from your dealer. See Accessories, page 27.
WARNING
Never install the heater
•in a bedroom or bathroom
•in a recreational vehicle
•where curtains, furniture, clothing, or other flammable objects are less than 36 inches from the front, top, or sides of the heater
•as a fireplace insert
•in high traffic areas
•in windy or drafty areas
CAUTION
WARNING ICON | G 001 |
This heater creates warm air currents. These currents move heat to wall surfaces next to heater. Installing heater next to vinyl or cloth wall coverings or operating heater where impurities in the air (such as tobacco smoke) exist, may discolor walls.
IMPORTANT:
Continued | 9 |
|
100098
