Desa CRL3124N Dual Burner Premium Aged Split Oak Models, Dual Burner Biltmore Split Oak Models

14

INSTALLATION

Installing Logs (Cont.)

INSTALLATION

Continued

Dual Burner Premium Aged Split Oak Models

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place the base of the middle log (#1) in the U-shaped slots of the grate base. The cutout on the right of the middle log should fit over the burner (see Figure 22). Make sure the front of the middle log is resting on the tabs of the grate base and the cut- out area is centered over the burner “U” bend.

2.Locate pins on the bottom of back log (#2). Slide these pins into the holes in the grate base behind the burner (see Figure 23).

3.Place crossover log (#3) onto the pin (right) on middle log (#1) and into the recess of the back log (#2). See Figure 24.

4.Locate the notches in the bottom of the front log (#4). Place the front log on the grate fingers. Make sure the notches of the front log line up with the grate fingers. See Figure 25.

5.With knot to right side, place smaller log piece (#5) over the pin on the left side of the middle log. The smaller log will rest on front log against the "knot" on the left. See Figure 26.

6.Place lava rock around base of heater if desired. Do not put lava rock on logs on burner.

Pin	Back Log (#2)	Crossover
		Log (#3)
Hole in
Grate		Recess
Base
		Pin

Burner
Figure 23 - Installing Back	Figure 24 - Installing Crossover
Log (#2)	Log (#3)
Front Log (#4)	Log Piece
	(#5)
Notches
	Pin

Middle Log (#1) Grate Fingers

Tab

Burner

“U” Bend

U-Shaped

Slot

Figure 22 - Installing Middle Log (#1)

Figure 25 - Installing Front Log	Figure 26 - Installing Log Piece
(#4)	(#5)

Dual Burner Biltmore Split Oak Models

WARNING: Failure to position the parts in accor- dance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.

CAUTION: After installation and periodically there- after, check to ensure that no flame comes in contact with any log. With the heater set to HI, check to see if flames contact any log. If so, reposition logs accord- ing to the log installation instructions in this manual. Flames contacting logs will create soot.

For..com

107123-01E