INSTALLATION

Installing Logs (Cont.)

17

INSTALLATION

Continued

Golden Oak Five-Piece Log Set

Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.

1.Place front log (#1) on top of the grate (see Figure 26). Log will fit down between grate and front of chassis.

2.Rest middle log (#2) inside “U”-shaped cutouts in chassis (see Figure 27).

3.Place rear log (#3) on back portion of chassis (see Figure 28). Log will "hug" the burner (see Figure 29).

4.Place right top log (#4) over logs #1, 2 and 3 as shown in Figure 29. Top log will sit down into indentions in these logs.

5.Place left top log (#5) over logs #2 and 3. Left top log will fit into indentions in these logs. IMPORTANT: Make sure logs do not cover any burner ports (see Figure 25, page 16).

6.Place lava rock around base of heater if desired.

1

3

Burner

Chassis

Figure 28 - Installing Golden Oak 5-Piece Log Set - Log 3

5

Grate

Chassis

Figure 26 - Installing Golden Oak 5-Piece Log Set - Log 1

Middle Log (#2)

Front Log (#1)

4

Rear Log (#3)

2

“U”-shaped Cutout

in Chassis

Figure 29 - Installing Golden Oak 5-Piece Log Set - Logs 4 and 5

Figure 27 - Installing Golden Oak 5-Piece Log Set - Log 2

For morevisit www..com

110399-01B

Page 17
Image 17
Desa LAME-MAX Golden Oak, FLAME-MAX VintageOak Golden Oak Five-Piece Log Set, Installing Golden Oak 5-Piece Log Set Log