Desa FVFM27PR Continued, OPTIONAL Hand-Held REMOTE OPERATION, On/Off Series Model HRC100, Piezo

OPERATING HEATER

Continued

OPTIONAL Hand-Held

REMOTE OPERATION

All remote control accessories must be pur- chased separately (see Accessories, page 25). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions on page 16.

After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere be- tween HI and LO. Slide the selector switch to the REMOTE position (see Figure 25). Note: The burner may light if hand-held remote was on when selector switch was last turned off. You can now turn the burner on and off with the hand-held remote control unit.

IMPORTANT: Do not leave the selector switch in the REMOTE or ON position when the pilot is not lit. This will drain the battery.

Piezo	Flame	Control Knob
Ignitor	Adjustment Knob	in On Position
	ON	IH	PILOT
		F	F
			O
	OFF	O
			N
	REMOTE	LO

Selector Switch in Remote Position (Optional Hand-Held Remote Control)

Figure 25 - Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for Hand-Held Remote Operation

On/Off Series (Model HRC100)

Hold the control button on the hand-held remote until burner turns on. Hold the con- trol button again until burner turns off (see Figure 26).

To Lock press both buttons on hand-held remote control until light stops flashing. Hand- held remote control is now locked. If the fire is on it will be turned off automatically. In the locked state, the light will not light up when any button is pressed.

To Unlock press both buttons together on hand- held remote control until the light stops flashing. The hand-held remote is now unlocked.

Indicator	Control
Light
	Button

Figure 26 - On/Off Hand-Held Remote

Control Unit

Thermostat Series (Model

HRC200)

The hand-held remote can be operated using either the manual mode (MANU) or thermo- static mode (AUTO) (see Figure 27). To select Fahrenheit/Centigrade mode display, carefully press the ˚C/˚F mode button with the end of a paper clip or similar blunt object.

	Digital Display Shows
Locks	Temperature and Settings
System to
Prevent	ROOM		SET	Turns Hand-
Accidental
Ignition		AUTO		Held Remote
	TEMP		TEMP
		TEMP		On or Off and
	LOCK		POWER	Allows You
Turns
				to Choose
Burners
				the Manual
On or Off	MANU	ºC/ºF AUTO
				Setting
Increases or				Selects
				AUTO
Decreases
				Mode
Room
Temperature in			°C/°F Mode Button
AUTO Mode

Figure 27 - Thermostat Hand-Held

Remote Control Unit

Manual Mode

1. Press the POWER and LOCK buttons togeth- er to turn on the hand-held remote control.

2. Press the MANU button to turn on the fireplace.

3. Press the POWER and LOCK buttons together to turn off the fireplace.

Auto (Thermostatic) Mode

1. Press the POWER and LOCK buttons together to turn on the hand-held remote control.

2. Press AUTO button to select this mode.

3. Set the desired room temperature by press- ing the TEMP + or - buttons.

4. Press the POWER and LOCK buttons together to turn off the fireplace

18 www.desatech.com 108382-01G